Electrical and Electronic Engineering - Research Publications
Permanent URI for this collection
Search Results
1 - 4 of 4
-
ItemSpectrally Selective Mid-Wave Infrared Detection Using Fabry-Pérot Cavity Enhanced Black Phosphorus 2D Photodiodes.(American Chemical Society, 2020-10-27)Thin two-dimensional (2D) material absorbers have the potential to reduce volume-dependent thermal noise in infrared detectors. However, any reduction in noise must be balanced against lower absorption from the thin layer, which necessitates advanced optical architectures. Such architectures can be particularly effective for applications that require detection only within a specific narrow wavelength range. This study presents a Fabry-Pérot cavity enhanced bP/MoS2 midwave infrared (MWIR) photodiode. This simple structure enables tunable narrow-band (down to 0.42 μm full width at half-maximum) photodetection in the 2-4 μm range by adjusting the thickness of the Fabry-Pérot cavity resonator. This is achieved while maintaining room-temperature performance metrics comparable to previously reported 2D MWIR detectors. Zero bias specific detectivity and responsivity values of up to 1.7 × 109 cm Hz1/2 W-1 and 0.11 A W-1 at λ = 3.0 μm are measured with a response time of less than 3 ns. These results introduce a promising family of 2D detectors with applications in MWIR spectroscopy.
-
ItemCopper Tetracyanoquinodimethane (CuTCNQ): A Metal-Organic Semiconductor for Room-Temperature Visible to Long-Wave Infrared Photodetection(AMER CHEMICAL SOC, 2021-08-18)Mid-wave and long-wave infrared (MWIR and LWIR) detection play vital roles in applications that include health care, remote sensing, and thermal imaging. However, detectors in this spectral range often require complex fabrication processes and/or cryogenic cooling and are typically expensive, which motivates the development of simple alternatives. Here, we demonstrate broadband (0.43-10 μm) room-temperature photodetection based on copper tetracyanoquinodimethane (CuTCNQ), a metal-organic semiconductor, synthesized via a facile wet-chemical reaction. The CuTCNQ crystals are simply drop-cast onto interdigitated electrode chips to realize photoconductors. The photoresponse is governed by a combination of interband (0.43-3.35 μm) and midgap (3.35-10 μm) transitions. The devices show response times (∼365 μs) that would be sufficient for many infrared applications (e.g., video rate imaging), with a frequency cutoff point of 1 kHz.
-
ItemLong-Wave Infrared Photodetectors Based on 2D Platinum Diselenide atop Optical Cavity Substrates(AMER CHEMICAL SOC, 2021-04-27)Long-wave infrared (LWIR) photodetection is of high technological importance, having a wide range of applications that include thermal imaging and spectroscopy. Two-dimensional (2D) noble-transition-metal dichalcogenides, platinum diselenide (PtSe2) in particular, have recently shown great promise for infrared detection. However, previous studies have mainly focused on wavelengths up to the short-wave infrared region. In this work, we demonstrate LWIR photodetectors based on multilayer PtSe2. In addition, we present an optical cavity substrate that enhances the light-matter interaction in 2D materials and thus their photodetection performance in the LWIR spectral region. The PtSe2 photoconductors fabricated on the TiO2/Au optical cavity substrate exhibit responsivities up to 54 mA/W to LWIR illumination at a wavelength of 8.35 μm. Moreover, these devices show a fast photoresponse with a time constant of 54 ns to white light illumination. The findings of this study reveal the potential of multilayer PtSe2 for fast and broadband photodetection from visible to LWIR wavelengths.
-
ItemLight-Matter Interaction Enhancement in Anisotropic 2D Black Phosphorus via Polarization-Tailoring Nano-Optics(AMER CHEMICAL SOC, 2021-04-21)Black phosphorus (bP), a two-dimensional (2D) layered material, has shown great potential for infrared (IR) optoelectronics owing to the narrow and direct bandgap it exhibits when in multilayer form. However, its thinness and optical anisotropy lead to weak light absorption, which limits the performance of bP-based photodetectors. In this work, we explore plasmonic nanoantennas, optical cavities, and their hybrids that can be integrated with multilayer bP to enhance its light absorption. This is achieved by near-field light intensity enhancement and polarization conversion. In addition, we demonstrate that these nanostructures can boost the spontaneous emission from bP. Light absorption enhancements of up to 185 and 16 times are obtained for linearly polarized and unpolarized IR light, respectively, in comparison with a commonly used device architecture (bP on SiO2/Si). Moreover, IR light emission enhancements of up to 18 times are achieved. The optical nanostructures presented here can be exploited for enhancing the detectivity of photodetectors and electroluminescence efficiency of light-emitting diodes based on bP and other 2D materials.