Engineering and Information Technology Collected Works - Theses

Permanent URI for this collection

Search Results

Now showing 1 - 3 of 3
  • Item
    Thumbnail Image
    A study of separation in turbulent boundary layers
    Fairlie, B. D. (University of Melbourne, 1973)
  • Item
    Thumbnail Image
    A distributed logic computer
    Dunn, Paul Alexander. (University of Melbourne, 1978)
    This thesis describes the development of a distributed logic computer. The computer employs a large number of processing cells instead of the usual single central processor connected to a large number of memory "cells". Each processing cell can contain either data or a stored instruction. In addition each processing cell is able to execute an instruction communicated to it. Instructions are transmitted from the cell in which they are stored to the data cell on which they are to act. At the completion of execution of an instruction/ the data cell concerned itself transmits an instruction to the next stored instruction to be transmitted for execution. The address of the following instruction cell is contained in the instruction previously executed, that is each transmitted instruction also contains the address of its successor, unless execution of the instruction stream is to cease. Communication between processing cells is accomplished by means of a communication network. This network consists of a tree-like arrangement of interconnected communication cells which conveys messages (instructions) from a source processing cell to a destination processing cell. The network employs packet switching using a relative processing cell address. Since no central processor is employed, there is no centralised control of address selection or execution. An arbitrary number of execution streams may proceed concurrently. Instructions have been provided which allow program divergence, to achieve parallelism, and which provide synchronisation at the completion of concurrent processes. A scheduling queue is included at the root of the communication network to provide mutual exclusion for critical resources. The problem of deadlock and the solutions used are discussed in some detail. The development and design features of the computer are described and the performance of both the communication network itself, and the processor as a whole, is discussed. The processor has been simulated in detail to allow a quantitative evaluation of various aspects of performance. The unique programming techniques associated with the processor are illustrated in detail. A symbolic cross-assembler has been used in conjunction with the simulator to assist in program preparation for execution, and assembly listings are included in illustrating programming techniques. One technique in particular which has received attention is referred to as "software pipelining" and measurements of performance of representative programs are discussed. Data flow principles are also examined in relation to the principles of operation of this computer.
  • Item
    Thumbnail Image
    A study of time-dependent properties and other physical properties of rocks
    Singh, Devendra Pratap ( 1970)
    The strength and deformation behaviour of rocks are time-dependent. Therefore the design of rock structures underground should be based on the long-term strengths rather than the strength determined by short-term laboratory tests. The direct method of determining the long-term strength of a rock is tedious and time consuming. Hence it is considered important that short-term methods of predicting long-term strengths of rocks be evolved. Short-term methods based on measurement of volumetric strain, stress-strain, log stress-log strain and loading rate were investigated. The long-term strength of Sicilian marble was determined by the direct method and was found to be close to the predicted long-term strengths by short-term methods. With the equipment used in this project, the leading rate method proved to be quicker and more accurate than other short-term methods as the processing and plotting of data were not involved in this case. The volumetric strain method predicted higher time-dependent strengths than the direct method. Dilatancy was observed in many intact rock specimens tested in uniaxial compression. It was also found that the values of Young's modulus and Poisson's ratio of a specimen are stress-dependent. All the three stages of the idealized creep curve i.e. transient, steady state and accelerated stage, were observed in Sicilian marble and Wombayan marble specimens. The lateral creep rate in the above two marbles was found to be larger than the axial creep rate at sustained stresses greater than their yield stresses. In the triaxial tests, in which only Sicilian marble specimens were tested, the ratios of predicted long-term strength to maximum strength showed a declining trend with increasing confining pressures. In the study of friction along the fractured surfaces of Sicilian marble specimens in the triaxial tests, it was found that during sliding the sheer stress and normal stress on the sliding plane have a straight line relationship. The average coefficient of friction for Sicilian marble was found to be 0.84.