- Infrastructure Engineering - Research Publications
Infrastructure Engineering - Research Publications
Permanent URI for this collection
2 results
Filters
Reset filtersSettings
Statistics
Citations
Search Results
Now showing
1 - 2 of 2
-
ItemNo Preview AvailableThe potential of wood gasifiers for tea drying in Sri LankaJAYAH, TH ; FULLER, R ; AYE, L ; STEWART, D (RERIC, 2001-12-01)One of the reasons for the higher production cost of tea in Sri Lanka compared to other countries is the high specific energy consumption. In Sri Lanka, 38% more energy is used to produce one kilogram of tea compared to India, largely because of the use of inefficient wood-fired air heaters. Gasifiers have been proposed as an alternative method of providing the hot air used for drying. A locally built gasifier has been tested and found to have a conversation efficiency of 80%, which is comparable to that of an imported unit. The heat loss of local gasifier was found to be between 11.5-14% of the input energy. An analysis shows that the life cycle cost of energy produced by the gasifier is US$ 3.00 per GJ, which is 8% less than the cost of energy from a conventional wood heater. Wood consumption is also reduced by 12%. Some transfer of gasifier technology to the crematoria industry in Sri Lanka has already occurred and this enhances the prospect of the successful introduction of this technology to the tea industry.
-
ItemComputer simulation of a downdraft wood gasifier for tea dryingJAYAH, TH ; AYE, L ; FULLER, RJ ; STEWART, DF (Elsevier, 2003-10-01)A gasifier has been fabricated in Sri Lanka for the tea industry, but there is a lack of knowledge of the effect of certain key operating parameters and design features on its performance. Experimental testing of the design under various conditions has produced data that has then been used to calibrate a computer program, developed to investigate the impact of those parameters and features on conversion efficiency. The program consists of two sub-models of the pyrolysis and gasification zones, respectively. The pyrolysis sub-model has been used to determine the maximum temperature and the composition of the gas entering the gasification zone. The gasification zone sub-model has been calibrated using data gathered from the experiments. It was found that a wood chip size of 3–5 cm with a moisture content below 15% (d.b.) should be used in this gasifier. Feed material with a fixed carbon content of higher than 30% and heat losses of more than 15% should be avoided. For the above parameters, the gasification zone should be 33 cm long to achieve an acceptable conversion efficiency.