School of Chemistry - Research Publications
Permanent URI for this collection
Search Results
1 - 10 of 19
-
ItemRevealing the Role of Methylammonium Chloride for Improving the Performance of 2D Perovskite Solar Cells(American Chemical Society, 2020-06-10)Layered perovskite films, composed of two-dimensional (2D) Ruddlesden–Popper perovskites (RPPs), show improved stability compared to their conventional three-dimensional (3D) counterparts in perovskite solar cells (PSCs). However, 2D PSCs exhibit a lower power conversion efficiency (PCE), which has been attributed to compositional inhomogeneity and nonuniform alignment of the 2D perovskite phases. Methylammonium chloride (MACl) has been adopted as an additive to improve the PCE and the operational stability of 2D PSCs, although the role of MACl in performance enhancement is unclear. In this work, time- and spatially resolved fluorescence and absorption techniques have been applied to study the composition and charge carrier dynamics in MACl-doped BA2MA4Pb5I16 (⟨n⟩ = 5) layered perovskite films. The inhomogeneous phase orientation distribution in the direction orthogonal to the substrate for undoped layered perovskite films undergoes reorganization upon MACl doping. Based on structural and crystallographic analyses, it is revealed that MACl can facilitate the crystallization of small-n 2D perovskite phases at the cost of consuming an increased amount of BA cations. Consequently, an increase in the thickness of large-n 2D perovskite phases accompanies their enhanced perpendicular alignment ([101] crystalline orientation) to the substrate, which facilitates charge carrier transport and collection by electrodes. The defect passivation of the MACl-doped layered perovskite film provided by the small-n phase is also beneficial to the photovoltaic performance of the PSC device. A maximum PCE (∼14.3%) was achieved at 6 mol % MACl doping, with this optimum level influenced by the increased interfacial roughness of the layered perovskite film caused by the edges of small-n perovskite flakes emerging on the front surface.
-
ItemResolving the Mechanisms of Photocurrent Improvement in Ternary Organic Solar Cells(AMER CHEMICAL SOC, 2019-08-01)The ultralow band gap small-molecule IEICO-4F has been employed as a secondary acceptor in both fullerene-based (PTB7-Th:PC71BM) and nonfullerene-based (PBDB-T:ITIC) ternary organic solar cells (OSCs). Structural characterization methods combined with ultrafast spectroscopy have been applied to resolve the mechanisms, leading to the observed improvement in device efficiency upon addition of IEICO-4F. It is shown that IEICO-4F forms ternary mixed domains in the host systems and improves the device efficiency by broadening the absorption spectral range and enhancing both charge separation and charge transport. The enhanced crystallinity of the semiconductor polymer electron donors in the presence of the EIECO-4 provides additional channels for ultrafast charge transfer and transport compared to binary systems. The optimum ternary blend formulations required to improve device efficiencies are reported. This work provides new insights into the fabrication of high-performance ternary OSCs.
-
ItemSpectroscopic study of L-DOPA and dopamine binding on novel gold nanoparticles towards more efficient drug-delivery system for Parkinson's disease(PERGAMON-ELSEVIER SCIENCE LTD, 2022-03-05)Nano-drug delivery systems may potentially overcome current challenges in the treatment of Parkinson's disease (PD) by enabling targeted delivery and more efficient blood-brain penetration ability. This study investigates novel gold nanoparticles (AuNPs) to be used as delivery systems for L-DOPA and dopamine by considering their binding capabilities in the presence and absence of a model protein, bovine serum albumin (BSA). Four different AuNPs were prepared by surface functionalization with polyethylene glycol (PEG), 1-adamantylamine (Ad), 1-adamantylglycine (AdGly), and peptidoglycan monomer (PGM). Fluorescence and UV-Vis measurements demonstrated the strongest binding affinity and L-DOPA/dopamine loading efficiency for PGM-functionalized AuNPs with negligible impact of the serum protein presence. Thermodynamic analysis revealed a spontaneous binding process between L-DOPA or dopamine and AuNPs that predominantly occurred through van der Waals interactions/hydrogen bonds or electrostatic interactions. These results represent PGM-functionalized AuNPs as the most efficient at L-DOPA and dopamine binding with a potential to become a drug-delivery system for neurodegenerative diseases. Detailed investigation of L-DOPA/dopamine interactions with different AuNPs was described here for the first time. Moreover, this study highlights a cost- and time-effective methodology for evaluating drug binding to nanomaterials.
-
ItemTriplet fusion upconversion using sterically protected 9,10-diphenylanthracene as the emitter(ROYAL SOC CHEMISTRY, 2020-03-21)Improving the efficiency of triplet fusion upconversion (TF-UC) in the solid-state is still challenging due to the aggregation and phase separation of chromophores. In this work, two 9,10-diphenylanthracene (DPA) derivatives based on the modification of the 9,10-phenyl rings with bulky isopropyl groups (bDPA-1 and bDPA-2) were used as emitters. By using platinum octaethylporphyrin (PtOEP) as the sensitizer, TF-UC performance was comprehensively investigated in 3 media: toluene solution, polyurethane thin film and nano/micro-crystals in a polyvinyl alcohol matrix. Only a small difference in upconversion efficiency between the bulky DPAs and the DPA reference was observed in toluene solution and polyurethane thin film. However, a large improvement of TF-UC quantum yield was achieved in bDPA-2/PtOEP crystals (ΦUC = (0.92 ± 0.05)%) with a low excitation intensity threshold (52 mW cm-2) compared to that of DPA/PtOEP crystals (ΦUC = (0.09 ± 0.03)%). This difference was largely attributed to improved dispersibility of the PtOEP sensitizer in the bDPA-2 emitter crystals. The bulky DPAs also show excellent stability under UV irradiation with exposure to oxygen compared to DPA. These results provide a strategy for developing efficient solid-state TF-UC systems based on nano/micro-particles of emitter-sensitizer mixtures.
-
ItemCompetitive Triplet Formation and Recombination in Crystalline Films of Perylenediimide Derivatives: Implications for Singlet Fission(AMER CHEMICAL SOC, 2020-05-28)Developing photostable compounds that undergo quantitative singlet fission (SF) is a key challenge. As SF necessitates electron transfer between neighboring molecules, the SF rate is highly sensitive to intermolecular coupling in the solid state. We investigate SF in thin films for a series of perylenediimide (PDI) molecules. By adding different substituents at the imide positions, the packing of the molecules in the solid state can be changed. The relationship between SF parameters and the stacked geometry in PDI films is investigated, with two-electron direct coupling found to be the main SF mechanism. Time-resolved emission and transient absorption data show that all of the PDI films undergo SF although with different rates and yields varying from 35 to 200%. The results show that PDI1 and 2, which are stacked PDI pairs twisted out of alignment along the highest occupied molecular orbital to lowest unoccupied molecular orbital transition, exhibit faster and more efficient SF up to 200% yield. We demonstrate that both triplet formation and decay rates are highly sensitive to the ordering of the molecules within a film. The results of this study will assist in the design of optimized structures with a fast SF rate and low recombination rate that are required for useful light harvesting applications.
-
ItemBilirubin analogues as model compounds for exciton coupling(ROYAL SOC CHEMISTRY, 2020-07-21)A series of phycobilin analogues have been investigated in terms of coupled excitonic systems. These compounds consist of a monomer, a tetrapyrrole structurally similar to bilirubin (bR), and two conjugated bR analogues. Spectroscopic and computational methods have been used to investigate the degree of interchromophore coupling. We find the synthesised bR analogue shows stronger excitonic coupling than bR, owing to a different molecular geometry. The excitonic coupling in the conjugated molecules can be controlled by modifying the bridge side-group. New computed energy levels for bR using the DFT/MRCI method are also presented, which improve on published values and re-assign the character of excited singlet states.
-
ItemNo Preview AvailableSelenium Nanoparticles as Potential Drug-Delivery Systems for the Treatment of Parkinson's Disease(AMER CHEMICAL SOC, 2023-09-20)
-
ItemQuantifying the Relaxation Dynamics of Higher Electronic Excited States in Perylene.(American Chemical Society, 2023-08-31)Gating logical operations through high-lying electronic excited states presents opportunities for developing ultrafast, subnanometer computational devices. A lack of molecular systems with sufficiently long-lived higher excited states has hindered practical realization of such devices, but recent studies have reported intriguing photophysics from high-lying excited states of perylene. In this work, we use femtosecond spectroscopy supported by quantum chemical calculations to identify and quantify the relaxation dynamics of monomeric perylene's higher electronic excited states. The 21B2u state is accessed through single-photon absorption at 250 nm, while the optically dark 21Ag state is excited via the 11B3u state. Population of either state results in subpicosecond relaxation to the 11B3u state, and we quantify 21Ag and 21B2u state lifetimes of 340 and 530 fs, respectively. These lifetimes are significantly longer than the singlet fission time constant from the perylene 21B2u state, suggesting that the higher electronic states of perylene may be useful for gating logical operations.
-
ItemA sandwich-like structural model revealed for quasi-2D perovskite films(Royal Society of Chemistry, 2021-04-28)The excellent performance and stability of perovskite solar cells (PSCs) based on quasi-2D Ruddlesden–Popper perovskites (RPPs) holds promise for their commercialization. Further improvement in the performance of 2D PSCs requires a detailed understanding of the microstructure of the quasi-2D perovskite films. Based on scanning transmission electron microscopy (STEM), time-resolved photoluminescence, and transient absorption measurements, a new sandwich-like structural model is proposed to describe the phase distribution of RPPs. In contrast to the conventional gradient distribution, it is found that small-n RPPs are sandwiched between large-n RPP phase layers at the front and back sides owing to crystallization initiated from both interfaces during film formation. This sandwich-like distribution profile facilitates excitons funneling from the film interior to both surfaces for dissociation while free carriers transport via large-n channels that permeate the film to ensure efficient charge collection by the corresponding electrodes, which is favorable for high-performance photovoltaics. This discovery provides a new fundamental understanding of the operating principles of 2D PSCs and has valuable implications for the design and optimization strategies of optoelectronic devices based on quasi-2D RPPs films.
-
ItemBrownian Tree‐Shaped Dendrites in Quasi‐2D Perovskite Films and Their Impact on Photovoltaic Performance(Wiley, 2022-05)Quasi-2D Ruddlesden–Popper perovskites (RPPs) are candidates for constructing perovskite solar cells (PSCs) with superior stability due to their tolerance to the external environment. Fully understanding the film growth mechanism and structure is crucial to further improve the performance of 2D-PSCs while maintaining device stability. In this work, the origin of Brownian tree-shaped dendrites formed in hot-cast methylammonium chloride (MACl)-doped BA2MAn−1PbnI3n+1 ( = 5) quasi-2D perovskite films are reported. Investigations based on optical, electronic, atomic force, and fluorescence microscopies reveal that the dendrites are assembled from large-n RPPs-dominated grains, while the nondendritic film area is composed of small-n RPPs grains and associated with film surface pits caused by the evaporation of MACl. It is proposed that these dendrites are grown by the diffusion-limited aggregation of the MA-rich intermediate phase domains that initially crystallize from the precursor. The formation of these dendrites in quasi-2D perovskite films upon MACl doping is accompanied by improved organization and crystallinity of the 2D RPPs, which benefits the photovoltaic performance. This work provides new insights into the formation mechanism of quasi-2D perovskite films that should assist device engineering strategies to further improve the performance of 2D PSCs.