School of Chemistry - Research Publications
Permanent URI for this collection
Search Results
1 - 10 of 19
-
ItemHighly Efficient Luminescent Solar Concentrators by Selective Alignment of Donor-Emitter Fluorophores(AMER CHEMICAL SOC, 2019-04-23)Vertically aligning fluorophores to the surface of a waveguide is known to be an effective approach to improve the optical quantum efficiency (OQE) of luminescent solar concentrators (LSCs). While the chromophore alignment assists waveguiding of the emitted photons to the LSC edges, it also significantly reduces the light-harvesting properties of the LSC. We report here a fluorophore pair consisting of a sphere-shaped energy donor and a rod-shaped emitter that was incorporated in LSCs to provide selective fluorophore alignment to address the reduced incident-light absorption issue. A liquid-crystal polymer matrix was used to perpendicularly align the rod-shaped acceptors to a favorable orientation for light guiding, while the sphere-shaped donor was randomly oriented to maintain its light-absorbing properties. The OQE of LSC devices with this selectively aligned donor-acceptor fluorophore system is 78% without significant loss of light-harvesting capability.
-
ItemCompetitive Triplet Formation and Recombination in Crystalline Films of Perylenediimide Derivatives: Implications for Singlet Fission(AMER CHEMICAL SOC, 2020-05-28)Developing photostable compounds that undergo quantitative singlet fission (SF) is a key challenge. As SF necessitates electron transfer between neighboring molecules, the SF rate is highly sensitive to intermolecular coupling in the solid state. We investigate SF in thin films for a series of perylenediimide (PDI) molecules. By adding different substituents at the imide positions, the packing of the molecules in the solid state can be changed. The relationship between SF parameters and the stacked geometry in PDI films is investigated, with two-electron direct coupling found to be the main SF mechanism. Time-resolved emission and transient absorption data show that all of the PDI films undergo SF although with different rates and yields varying from 35 to 200%. The results show that PDI1 and 2, which are stacked PDI pairs twisted out of alignment along the highest occupied molecular orbital to lowest unoccupied molecular orbital transition, exhibit faster and more efficient SF up to 200% yield. We demonstrate that both triplet formation and decay rates are highly sensitive to the ordering of the molecules within a film. The results of this study will assist in the design of optimized structures with a fast SF rate and low recombination rate that are required for useful light harvesting applications.
-
ItemFRET-enhanced photoluminescence of perylene diimides by combining molecular aggregation and insulation(Royal Society of Chemistry, 2020-07-14)The photoluminescence quantum yield (ϕPL) of perylene diimide derivatives (PDIs) is often limited by aggregation caused quenching (ACQ) at high concentration or in the neat solid-state. Energy transfer in high dye concentration systems is also a key factor in determining ϕPL as a result of energy funneling to trap sites in the sample. By tuning the substituents, we present two classes of PDIs with aggregation and insulation of the PDI core. By combining these fluorophores in a polymer film, we demonstrate highly emissive samples (85% ϕPL) at high concentration (140 mM or 20% w/w). Experimental and theoretical studies provide insight into why such a combination is necessary to achieve high ϕPL. While insulated fluorophores maintain respectable ϕPL at high concentration, an improved ϕPL can be achieved in the presence of appropriately oriented fluorophore aggregates as emissive traps. The theoretical calculations show that the relative orientation of aggregated monomers can result in energetic separation of localized states from the charge-transfer and bi-excitonic states thereby enabling high ϕPL.
-
ItemTetraphenylethene 9,10-Diphenylanthracene Derivatives - Synthesis and Photophysical Properties(WILEY-V C H VERLAG GMBH, 2019-06)A series of tetraphenylethene 9,10-diphenylanthracene (TPE-DPA) derivatives have been synthesized, and their photophysical properties studied. Photoluminescence measurements in PMMA, neat films and nanoparticle dispersions reveal that different aggregation states are formed, which leads to different photophysical behavior. The triplet excited state properties were studied using Pt(II) octaethylporphyrin (PtOEP) as triplet sensitizer. Upconverted emission from the DPA moiety is observed in nanoparticle dispersions of each derivative. A higher upconverted emission intensity is observed in aerated (compared to deaerated) solutions of the derivatives following irradiation, which is attributed to oxidation of the TPE moiety. These results provide valuable insight for the design of AIE luminogens for triplet-triplet annihilation upconversion (TTA-UC).
-
ItemOptimising molecular rotors to AIE fluorophores for mitochondria uptake and retention(ROYAL SOC CHEMISTRY, 2020-12-07)Molecular rotors exhibit fluorescence enhancement in a confined environment and thus have been used extensively in biological imaging. However, many molecular rotors suffer from small Stokes shift and self-aggregation caused quenching. In this work, we have synthesised a series of red emissive molecular rotors based on cationic α-cyanostilbene. Profoundly enhanced aggregation-induced emission (AIE) properties and greatly widened Stokes shifts can be achieved by molecular engineering. With specificity to stain mitochondria, we demonstrate a simple approach to achieve cell uptake and retention upon tuning the pyridinium substituent of the dyes.
-
ItemA Molecular Chameleon for Mapping Subcellular Polarity in an Unfolded Proteome Environment(WILEY-V C H VERLAG GMBH, 2020-06-15)Environmental polarity is an important factor that drives biomolecular interactions to regulate cell function. Herein, a general method of using the fluorogenic probe NTPAN-MI is reported to quantify the subcellular polarity change in response to protein unfolding. NTPAN-MI fluorescence is selectively activated upon labeling unfolded proteins with exposed thiols, thereby reporting on the extent of proteostasis. NTPAN-MI also reveals the collapse of the host proteome caused by influenza A virus infection. The emission profile of NTPAN-MI contains information of the local polarity of the unfolded proteome, which can be resolved through spectral phasor analysis. Under stress conditions that disrupt different checkpoints of protein quality control, distinct patterns of dielectric constant distribution in the cytoplasm can be observed. However, in the nucleus, the unfolded proteome was found to experience a more hydrophilic environment across all the stress conditions, indicating the central role of nucleus in the stress response process.
-
ItemA Molecular Chameleon for Mapping Subcellular Polarity in an Unfolded Proteome Environment(Wiley, 2020-06-15)Abstract Environmental polarity is an important factor that drives biomolecular interactions to regulate cell function. Herein, a general method of using the fluorogenic probe NTPAN‐MI is reported to quantify the subcellular polarity change in response to protein unfolding. NTPAN‐MI fluorescence is selectively activated upon labeling unfolded proteins with exposed thiols, thereby reporting on the extent of proteostasis. NTPAN‐MI also reveals the collapse of the host proteome caused by influenza A virus infection. The emission profile of NTPAN‐MI contains information of the local polarity of the unfolded proteome, which can be resolved through spectral phasor analysis. Under stress conditions that disrupt different checkpoints of protein quality control, distinct patterns of dielectric constant distribution in the cytoplasm can be observed. However, in the nucleus, the unfolded proteome was found to experience a more hydrophilic environment across all the stress conditions, indicating the central role of nucleus in the stress response process.
-
ItemSingle Isomer of Indene-C70 Bisadduct-Isolation and Performance in Bulk Heterojunction Solar Cells(AMER CHEMICAL SOC, 2014-02-25)
-
ItemConcentrating Aggregation-Induced Fluorescence in Planar Waveguides: A Proof-of-Principle(NATURE PORTFOLIO, 2014-04-10)The photophysical properties of fluorescent dyes are key determinants in the performance of luminescent solar concentrators (LSCs). First-generation dyes--coumarin, perylenes, and rhodamines--used in LSCs suffer from both concentration quenching in the solid-state and small Stokes shifts which limit the current LSC efficiencies to below theoretical limits. Here we show that fluorophores that exhibit aggregation-induced emission (AIE) are promising materials for LSC applications. Experiments and Monte Carlo simulations show that the optical quantum efficiencies of LSCs with AIE fluorophores are at least comparable to those of LSCs with first-generation dyes as the active materials even without the use of any optical accessories to enhance the trapping efficiency of the LSCs. Our results demonstrate that AIE fluorophores can potentially solve some key limiting properties of first-generation LSC dyes.
-
ItemMorphology Change and Improved Efficiency in Organic Photovoltaics via Hexa-peri-hexabenzocoronene Templates(AMER CHEMICAL SOC, 2014-06-11)The morphology of the active layer in organic photovoltaics (OPVs) is of crucial importance as it greatly influences charge generation and transport. A templating interlayer between the electrode and the active layer can change active layer morphology and influence the domain orientation. A series of amphiphilic interface modifiers (IMs) combining a hydrophilic polyethylene-glycol (PEG) oligomer and a hydrophobic hexabenzocoronene (HBC) were designed to be soluble in PEDOT:PSS solutions, and surface accumulate on drying. These IMs are able to self-assemble in solution. When IMs are deposited on top of a poly(3,4-ethylenedioxythiophene) poly(styrenesulfonate) (PEDOT:PSS) film, they induce a morphology change of the active layer consisting of discotic fluorenyl-substituted HBC (FHBC) and [6,6]-phenyl C61-butyric acid methyl ester (PCBM). However, when only small amounts (0.2 wt %) of IMs are blended into PEDOT:PSS, a profound change of the active layer morphology is also observed. Morphology changes were monitored by grazing incidence wide-angle X-ray scattering (GIWAXS), transmission electron microscopy (TEM), TEM tomography, and low-energy high-angle angular dark-field scanning transmission electron microscopy (HAADF STEM). The interface modification resulted in a 20% enhancement of power conversion efficiency.